Daily Archives

One Article

News

Firearms By The Cano Exhaust

Posted by Sylia on

Whom no sono ever with this spectacular effect. From the fast and the furious film more and more vehicles can be seen with this detail. This article is not intended to be a perfect guide for installation, but its purpose is only information on how carries out the process of placement, so we recommend to leave the system to persons with experience in such work. The system basically works with leaks produced by the combustion of the fuel getting into operation via a light switch. Add to your understanding with Ebay. To accelerate the car at about 3,000 rpm and pressing this button after 3 seconds the auto tension is interrupted through another coil producing raw gas out exhaust pipe. (As opposed to Ebay). These gases are ignited by the action of a spark plug. As this system itself what it does is create a fault so that the gases come out crude oil from the exhaust is likely that the car tends to turn off.

It is generally easier to use it when the vehicle is running because this will not be so prone to turn off as if it were arrested, being able to also keep the fire effect for more time. For the realization of the system is required, in addition to much care, the following elements: a 5 prong relay, a spark of long leg and a tower for this (which are used to troubleshoot when a cylinder presents traces of oil and bind the spark plug), coil ignition (to which will call coil fire henceforth to distingirla clearly from the original coil that comes with the car)a button 2 contacts and cable number 14. Wiring the relay for wiring 5 prong relay connects 87 and 30 terminal to a wire that comes from the negative of the original coil of auto (both are coming from the negative cable). The 85 terminal is connected to the battery plus. Terminal 86 goes to one of the existing push button terminals. 87 Terminal connects to the negative on the new spool. Coil installation of fire in the majority of cases fire coil is placed in a location near a tailpipe, generally within the trunk. The coil has two terminals, as it We explained above the negative of the coil must be connected to 87 of the relay, while the positive terminal is coneta to battery positive. Install the spark plug and its Tower Tower should be placed in the exhaust so the spark plug screw on this is at least located halfway through the exhaust pipe. Placement of the pushbutton the pushbutton has 2 terminals, as I was mention above one of them goes connected to terminal 86 of the relay, while the other goes to ground original author and source of the article